Hi Bob, Sorry to be confused and I hope I'm not confusing someone else, or missing an important post on this subject. I am looking at my copy of drawing H-8...
Probably alot of the regular posters are at cabin fever and will be back on-line in a few days. I sure hope so. my education isn't finished yet. ... Service....
A few of us are still here. If you need to further you education, as we all do, look into some of the other groups on yahoo. There are quite a few now, if...
Hi All, I'm new to the list. I saw the beautiful engine workmanship at your Yahoo group site that caught my interest when I was looking up groups devoted to ...
Yeah it sure is John. Is this the John Guenther I used to see at Tom's Hobby Hanger now and then? Andrew ... From: j.guenther [mailto:j.guenther@...] ...
Yes sir, it sure is. I don't do RC any more, but I am into engines and machining. If I remember correctly, someone out of the Carolina's used to market a...
Hi, I have started on the Little Angel engine and notice that the slot down the middle of the frame has a radius cut on the bottom of the slot. Is there any...
Hey John, Good to hear from you again. .. . small world! I wondered if you were still in the area. I'm going to need to swing a 32-35 inch four bladed prop...
None that I know of. I think the radius was purely for aesthetic purposes and not for any other reason. I just looked at a small engine, about the same size...
... Andrew, if you look at the web page for this group, you can see the numbers of messages posted each month. If you do the same with the following two...
... Tom, have you dropped a note to Bob Shores? I'm sure he would answer you. Or, sign up on the FAME site and ask the question there. I think that's...
HI, Does anyone happen to have the bore and stroke specs handy for the Challenger V8? If so, would you please post them? John Guenther 'Ye Olde Pen Maker' ...
In a message dated 1/23/03 1:43:29 PM Eastern Standard Time, j.guenther@... writes: << Does anyone happen to have the bore and stroke specs handy for...
Hi all, I am a student of Mechanical Engineering and working on the design of a IC Engine TestBed. I am right now at the initial stage of my design. Any ideas,...
The original messages were from me.. .745 is the correct number I think. If you have the gears, you can verify easily enough. I need to go back and check mine...
Thanks. I ended up emailing Bob and he replied with a very short 're-read the post - I answered it correctly the first time' style of answer. His answer was a...
Phil, I have not built the Hercules but I do have the drawings. You are correct that the drawings have different dimentions. This is how I solved the problem....
I have some questions on using a TIM - 4 ignition, on a "V" twin / 90 degree / one crank pin (rods )/ 4 cycle engine, with CCW cam & crank rotation. I plan on...
Good morning all, How do you determine the appropriate firing order for a multi cylinder engine design? I know you could copy existing 1:1 engines but suppose...
I've really gotten interested in miniature engines and I was just wondering where people get the plans to build these engines. Or do you all just design your...
Hi Chris one place you can get plans and casting is from Bob Shores his They are a good place to start http://www.bobshores.com/pages/1/index.htm Ken ....
