I adjusted my brakes on my TEA 20 and they still didn't lock up when road tested. I was told the camshaft could be jammed up, which one was. I pulled the...
It sounded like you got some axle bolts not vert tight so the brake backing plate is shifting back and forth. Richard raedan17 <raedan17@...> wrote: I...
Hi all a fellow up the road needs a starter drive for a TEA this is a 6 volt starter he says so if anyone knows where he can get one in canada would be great. ...
I am a fergie owner and have owned my TO35 for quite a few years. I am now in the process of restoring it. Anyway, why I am here is I have a friend that owns a...
tell him to try this link http://www.johnnypopper.com/ more info than you need about the JD and clubs I used to have a 49 A real big workhorse of a tractor. ...
Hi can anyone please tell me the fuel capacity of a tef20 diesel? Is it the same as the petrol, petrol / tvo models- 8gallons? thanks in advance Mark. ...
Hello Here's one tractor owner from Finland. We have had a good winter with about 80cm of snow. My TEA-20 has done great job keeping our yard and driveway...
aki: I once had a problem with an 8N Ford lift arm (same system). It got moisture in the fluid and when below freezing would not lift or lift very slowly. ...
Would anyone know what I should do? I've changed the points but the distributor is jammed on the shaft and I can't move it to be able to set the timing as at...
well, Danny, it should be fixed properly but...... if you need the tractor to do a job you can adjust the point gap to affect timing. A slightly smaller gap...
I am restoring a Ferguson TED-20 and I was wondering if anyone can give me instructions on fitting the water temperature gauge and the oil pressure gauge. ...
Hi there, We are very new to the world of tractors and I am currenty shopping around for something suitable for our property. The local guru has said I need...
here is a tractor for sale in the UK on ebay just go to www.ebay.com and search for 2469703724 any of the UK guys that might need parts should have a look at...
this fellow has some parts that he wants to sell they are new or rebuilt seems like an ok guy if anyone needs a generator, or voltage regulator or new fan belt...
I have a TO-20 with a problem, the lift spring control plunger threads are stripped and I need to make a new one ( $160 at MF dealer) Question? is the rod on...
Hi, My TED-20 usually starts fine but all it will do is turn over and I was wondering if anyone has any suggestions on what could be wrong and how to fix it....
Just a guess out of the blue is you may have a bad condenser in your distributor. You have to determine if you have spark and fuel. and go from there. regards...
Hi, new member here. I belong to an E.D.G.E. tractor club (antiques). We will be hosting the Midwest Regional Tractor Show in Fall 05. Am looking for Ferguson...
Get a meauring bucket and empty the tyre's water contents into the bucket. Bucket at a time. Finding out the quantity of water in the tyre. Water weighs a...
where is it at? ... From: mohens [mailto:rozlayne@...] Sent: Monday, March 29, 2004 7:54 PM To: fergusontractorclub@yahoogroups.com Subject: [Ferguson...
Hi Can someone answer a question. I have a great TED20 that runs great. The problem is that it will no longer start. The ignition key was left switched on...
if it has points the points can burn off if they are closed when the key was left on you can see if they are burnt just take dist cap off since it will not ...
he does not say if wiring is original or has been changed if it has a resistor in the wire to the coil to cut voltage to the points that could have burnt out I...
