Do I need a press or any special tools to replace this pin? What is the proper proceedure? I belive that John gave me the information a couple of years ago...
When I replaced the front axle pin on my tractor I had to press the old one out. You will also need to replace the centre bushing which will need to be press...
The factory way to remove these pins is to remove the holding cap screw, then use a slide hammer in the slot to pull out the pin. (jack up tractor front end,...
G’day All, My TED 20, when I bought her, had been modified and was fitted with a Lucas 15AC alternator, in a negative earth system situation. Soon after I...
Thanks all for your advice. I have the pin on order and I guess I should get the bushing ordered as well. John, I will email you when I get the front end...
Steve I'm in the process of scrapping a TE 20 which I believe has the same push rods as a TO-30. If you don't find one by mid July check back with me. I should...
Measure a good push rod and post its size, I may have one. You can always buy a new one cut to the exact size. If you need more info write me back and I'll...
Hi there, I'm wondering if you might have some experience that would help me.. I have a TEA-20 that I use on my small property in the victorian high country. ...
If you are getting that calcification and it is stopping the fuel flow, fitting a new carburettor will not cure the problem permanently as it will do the same...
thanks for the info.. as far as I know everything is 'standard' on the fuel side.. I've ordered a new fuel filter/bowl as the stop tap in mine is broken ...
Please make sure the vent hole built into the gas tank cap is open. ... the fuel ... is broken ... a "carby ... property.. ... carby to ... run well ... choked...
If your using 90% gas &10% ethanol for fuel, the ethanol is a very good solvent and will clean your fuel tank/fuel line etc. If so you need a auto type fuel...
I wasn't thinking of a lead replacement additive as it isn't necessary with these engines. I was thinking more of an upper cylinder lubricant, that was why I...
Hi Vaughn, I am no expert and have not even done a carby rebuild like your self but I did get problems with my TEA-20 just outside Geelong that it would cut ...
Can I suggest another possible cause? I too have done up a carbie (on my TEA20) to find some improvement but the real problem proved to be the condenser...
thanks to all that have responded. I should have sought out this advice a long time ago!!.. The only bit i haven't replaced in the electricals is the...
... advice a ... Really, the condenser is the first thing you should change, they may be small but they can cause big trouble. It will be interesting to find...
I'm following this 'carbie' track with rising excitement - it's a genuine mystery thriller - whodunnit? just one idle query - do you Ozzies call your Fergy -...
I call mine start you bitch Danny {a private communication, but I couldn't resist sharing it with y'all - hope that's OK , Danny.) Dick Q [Non-text portions...
Hi, could youall help me I have seen many Fergusons with a front bumper we own a 1950 TO-20 that does not.Were they an option? Were they aftermarket? Any...
... bumper ... Thosr Front bumper are very hard to find. The correct Bumper have drop down from the front Axle and hinged down to clear the Tilting Hood....
I've just visited my TEF which has stood in my friend's workshop for over a year while I moved house. I connected the charged-up battery, primed the fuel pump,...
Hi Paul Thanks for your reply, heres what I'm looking for, I have a 54 TO30 with a Z129. I'm looking for a replacement engine pushrod. Legnth is 8 3/4 inch ...
I read all of the good information from past postings and decided to try the WD40 route to free up my clutch. I purchased it from a man in Michigan, he said it...
