just two quick questions, i am new to the ferguson tractors and have just purchased a 1950 TO-20. My questions are.. do i need to use a lead substitute in...
... have ... a ... thanks. ... I would not use a lead substitute, if the tractor has ever been rebuilt and I am sure it has, as it has a few years on it. The...
... will overfill when setting. Does the amount of gas in the tank make a difference? Did you check the float valve seating? I overhauled my Marvel on the...
There is no need to use a lead substitute on these engines as they were designed to run on poor quality fuel which did not have any lead content. Engine oil...
the z134 engine is in multiple tractors, ie. 35, 50, 135. my question is can the exhaust manifold from say te 35 be used as a substitute on the 50. I've got...
TO-20 starts and idles fine. worked it for a while yesterday around the yard with a blade on the back and it ran fine for the first 20-30 mins. after that it...
Hi, it sounds like you are gradually getting gas-starved. Clean out the gas line between tank and carb and make sure no sediment is in the tank. If that...
... through the entire fuel syestem carb kit compressed air and drained gas ttank---turned out the govener was out of adjustment just a hair----- put it back...
Also be sure to chech the shut-off valve in the bottom of the gas tank. If this is clogged up with sediment it can cause the symptoms you are describing. cjh ...
... tank. If this is clogged up with sediment it can cause the symptoms you are describing. ... further to the fuel problem, there is a gauze filter on top of...
i need to know how to adjust the gov on a 1950 TO 20. tractor is running fine but when under a load, say like mowing, the gov. does not kick in. any...
Hi Scott, If you email me at fergusontractors@... I will send you the information that you need together with pictures and drawings to help you. Just...
Hello everyone Thanks for letting me take part in the group. I may not have any good tips for you because I am just learning but it is great to have a chance...
The engine oil should be SAE40 and this is OK for the Hydraulics as well, although you can use 15W/40 Multi-grade if you are in a cold winter climate as it...
Hi Everyone, Thanks for letting me join your group. I do not have a lot of information to offer on these tractors, but I know i can learn a lot from the...
I use 90 wt Gear Oil in my tranny and axle. That is what seemed to be recommended. Hal ... From: just_john10 To: fergusontractorclub@yahoogroups.com Sent:...
... of the rear, trans, and gear box through that one fill hole/ ... be recommended. ... as ... cold ... an ... a ... galls ... under ... sludge, so ... if ......
90 weight GEAR oil is definitely NOT recommended. The original spec of the oil was GL1 90W which is NOT the same as SAE90 Gear Oil. To compare the GL1 90W with...
... for engine, trans, and Hydra, and they fill from the port next to the gear shift, is that correct, and that feeds all of the three needs? ... Axle ... some...
Yes it will work, BUT if it is as cold as you say try Multi-grade in the Transmission, it will not get as thick when cold. For the engine the following grades...
Just to explain any misunderstanding there maybe about the "Gear Oil" the oil that was recommended by the manufacturer WAS a gear oil but without any sulphur...
Right behind the gear shift lever. And it does fill up the whole works from the trans thru the rear. ABout 6 gallons in all. Hal ... From: trivers5569 To:...
... not ... Ferguson TO 20 Governor is a tractor that could be 60 years old. The engine has been rebuilt at least one time and maybe more. One thing that...
Even if the bearings are bad you don't always get any movement that would suggest wear i.e.side to side etc. the needles can wear and it will lock the shaft up...
I am need of the throttle linkage that goes between the hand lever (located at steering wheel) and governing rod. Its the ball link on both ends and about 4"...
My PTo is loosing fluid, how hard is it to fix that. Is there a seal that can be replace or do i have to replace all the parts that the manual show.. there 21....
... <trivers5569@...> wrote: Yes there is a seal. Not too much effort to replace it in the TO30. I ordered a gasket also and got 1 package with 10 gaskets - so...
When changing the pto seal you may want to try parking it on a hill or with the nose down in a ditch. This way you will be able to save the fluid. If it is...
